T630LEDT

Small LED Trapezoidal Cut-off Wall Pack (Turtle Friendly)

Turtle Friendly

Use of Product
These luminaires are recommended for use in areas where artificial lighting is needed adjacent to ecologically sensitive areas, sea turtle nesting beaches, migratory corridors, and Dark Sky Friendly communities. wall mounted fixtures shall be installed at a maximum mounting height of 8 feet from the floor and are not recommended for use above the first habitable floor when located on the shore perpendicular or beachside of a structure.
 
Housing
Rugged die cast aluminum housing with hinged front frame. 1/2” coin plugs with O-rings for conduit & photocell. Includes Full Baffle Required to Maintain Florida Fish & Wildlife Conservation Commission certification.
 
Finish
Matt-finished, architectural bronze powdercoat over a precise chromate conversion coating. Available in standard dark polyester bronze or consult factory for made to order architectural finishes.
 
Optics
Tempered clear flat glass lens is sealed by one-piece silicon gasket prohibits entrance of outside contaminants.
 
Amber LED
LED operate between 585 and 595 nm. Aluminum boards
 
Driver
Electronic Driver, 120-277V, 50/60Hz; Standard internal surge protection 2kV. 0-10V Dimming standard for dimming range of 100% to 10%.
 
Mounting
Cast-in template for mounting directly over a  4” recessed outlet box  or 1/2” surface conduit.
 
Controls
Fixtures ordered with factory-installed photocell or motion sensor controls are internally wired for switching and/or 1-10V dimming within the housing. remote direct wired interface of 1-10V dimming is not implied and may not be available, please consult factory. fixtures are tested with LEPG controls and may not function properly with controls supplied by others. fixtures are NOT Designed for use with line voltage dimmers.
 
Listings/compliance
• CSA - Listed for wet location.
• ANSI/UL 1598
• 8750 IP65 sealed LED compartment