T621IND

12" Polycarbonate Induction Wall Pack

Induction

USE OF PRODUCT
The intented use of this product is for any outdoor commercial or industrial building accent decorative wall mount, public access area, recreation areas, stairwell & corridor applications.

HOUSING
Rugged die cast aluminum housing. Front housing is hinged with stainless steel hinged pins and safety cable for easy access to fixture compartment. Top and side coin plugs for easy conduit access.

FINISH
Textured architectural bronze powdercoat finish over a precise chromate conversion coating. Available in standard dark polyester bronze or consult factory for made to order architecural finishes.

OPTICS
Specular anodized aluminum reflector with vandal resistant polycarbonate prismatic lens. Lens is sealed by a one-piece silicon gasket prohibits entrance outside contaminants.

ELECTRICAL - DRIVER
• Input Voltage: 120V - 277V
• Input Frequency: 50/60 Hz
• Output Frequency: 250KHz - 365KHz

INDUCTION LAMP
Available in 40W, or 60W.

MOUNTING
Mounted over a 4” recessed outlet box or use a 1/2” surface conduit.

LISTINGS/COMPLIANCE
• CSA -Suitable for wet locations.

Similar Products

T623IND

Large Curved Semi-Cutoff Induction Wall Pack

T625IND

Large Curved Semi-Cutoff Induction Wall Pack

T626IND

Large Induction Wall Pack